Welcome to

duker.co.nz

 
| SML | MLetec | VML | Couplings |
 
Navigation
.
.
.
.
.
.
.

Company Details
.

 

COMPANY PROFILE

 

Product Benefits

 

Non-combustibility
Cast iron with lamellar graphite as per EN 1561 corresponds to construction material class A1 as per German standard DIN 4102 and is non-combustible.
For comparison: all plastic materials used for sewage pipes belong to class B1 (flame-resistant) or even B2 (inflammable). In case of fire, they can transmit fire through walls and ceilings, emit toxic gas and create dangerous compounds with quenching water.
Düker cast iron sewage pipe systems are different: cast iron does not burn and doesn't emit any gas in a fire. Expensive fire protection collars, which serve to prevent fire spreading over plastic pipes, are not necessary.

 
Up to 400ºC, the mechanical properties of cast iron pipes remain unchanged (for some plastic pipes this is only true up to 70ºC), the melting point is at 1300ºC. Thermal conductivity and thermal expansion are considerably lower than for plastics. Therefore expensive expansion joints and similar parts are not necessary. The thermal expansion coefficient of cast iron corresponds to that of concrete, so the installation in concrete is no problem at all.
 

Noise protection
The graphite particles embedded in the cast iron in lamella form serve to refract sound waves until they practically run out of energy. Also the considerable density - in comparison with plastics - absorbs sound waves.
Sound waves transmitted by air are thus mostly absorbed. Those transmitted by solids are reduced due to rubber sealing in the couplings and the fixings that prevent direct contact between the pipe system and the wall or ceiling as well as between the pipe system components.
If a pipe system is installed expertly, waste water flow noise from Düker cast iron sewage pipe systems is not a problem even without additional noise insulation.
 

Durability
Cast iron sewage pipes have been proving themselves for centuries, for unlike other materials, cast iron does not age or become brittle with time.
If the installation is carried out expertly, ventilated sufficiently and using the suitable coating variant, corrosion is not a problem either for the durability of Düker cast iron sewage pipe systems.
If, for visual effect, the rusting of SML pipes is to be avoided, the pipe system can be coated with anti-corrosion coatings suitable for steel. This is recommended particularly for pipes and fittings outside of buildings (rain water down pipes etc.).
SML pipes embedded in concrete are protected excellently by the surrounding concrete.
 

Stability
Often cast iron rain standpipes are used to protect the lower part of rain water down pipes from damage.
The same stability distinguishes cast iron sewage pipes and fittings during transport and on the building site. They also prove themselves in multi-storey car parks or in places where they defy vandalism.
This solidity also allows to do with considerably fewer fixings than for plastic pipe systems. A 3 m cast iron pipe is supported with only two pipe fixings - a considerable cost and time factor.
 

Recycling
cast iron sewage pipes and fittings Dükercan be completely recycled, and they are manufactured from iron and steel scrap in a percentage of 95%. Cast iron has been a recycled product for centuries. Most plastic pipes, however, are not recycled, but burnt or disposed of.
 

Epoxy coatings
The interior surfaces of pipes as well as the fittings of the Düker cast iron sewage pipe systems SML, TML, MLB and MLK are equipped with high-quality, fully cross-linked epoxy coatings.
These epoxy interior coatings surpass the requirements of the product standard EN 877 by far. Furthermore, the manufacture of the pipes using the centrifugal casting procedure guarantees extremely smooth interior walls which facilitate an even, nonporous and elastic epoxy layer.
 

Zinc coating
Düker TML pipes as well as the MLB drainage pipe system are equipped with a multiple layer exterior coating, with a zinc layer below the cover coat to ensure the corrosion protection required for the respective application.

---------------------------------------------------------------------------------------

Please contact us for all your enquiries, and we will respond during business hours.

COMPANY PROFILE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Copyright © 2002 - 2004 DUKER NZ LTD. DUKER.CO.NZ. All Rights Reserved.

Website Designed by Vamsee